This can simplify IP/MAC binding configuration, but can also neutralize protection offered by IP/MAC binding if untrusted hosts are allowed to access the DHCP server. If this is not done, the new or changed hosts will not have access to or through the FortiGate unit depending on the settings configured.Ĭaution: If a client receives an IP address from the FortiGate unit DHCP server, the client's MAC address is automatically registered in the IP/MAC binding table. Note: If IP/MAC binding is enabled, and the IP address of a host with an IP or MAC address in the IP/MAC table is changed, or a new computer is added to the network, it is necessary to update the IP/MAC table.
As mentioned earlier, if any routing takes place before sending traffic to a FortiGate the issue of source MAC address being replaced with that of a router is a real concern. Extra caution is required to implement in large networks. This is only recommended in small to medium networks. Using CLI, an Administrator may configure manual binding table and configure which MAC address corresponds to which IP address. e.g.The feature used in this procedure is called IP/MAC binding. If this doesn't help, please try disabling "Allow direct connections" in Settings > Connection and then "General" on both computers.Īlternatively, try adding "/np" at the end of the AnyDesk-ID/Alias you're trying to connect to. Please also make sure exceptions have been made for AnyDesk for any other security solutions such as antiviruses on both the remote and local devices. More information about this can be found in our Help Center at. Please make sure your firewall on both the local and remote devices as well as networking hardware such as routers do not interfere with AnyDesk's connection. every 30 seconds, every 10 minutes, etc.)? It could be that there is a security solution on the local or remote endpoints that is going through all active connections every few minutes and disconnecting the ones from "unknown" or "untrusted" IP-addresses. The session keeps on disconnecting! What can I do?ĭoes the session disconnect at regular intervals (e.g. Administrator Privileges and Elevation (UAC)ĪnyDesk for Linux / Raspberry Pi / FreeBSD
0 kommentar(er)
